JBO-001 manual（www.obdcars.com）
1.
Status indicators
l GPS positioning indicator:
On permanently Not fixed
Blinking Fixed
l OBD indicator: On permanently Not connected with car
Blinking Connected with car
l GSM indicator: Slow blinking Not registered
Quick
blinking Registered
2.
Buzzer alarm
l Excessive speed：If the speed is higher than the set value, the buzzer will sound
alarm tone every three minutes.
l Coolant temperature: if the coolant temperature is higher than the
set value, the buzzer will sound alarm tone every three minutes.
l Drowsy driving: if the duration of driving is higher than the set
value, the buzzer will sound alarm tone every three minutes.
l Serious engine fault: If a serious engine fault occurred, the buzzer
will sound alarm tone every three minutes.
l Normal engine fault: if a normal engine fault occurred, the buzzer
will sound a BEEP tone.
3.
Enable vibration detection
l When engine was off and the OBD indicator was in On permanently
status, call the terminal through the registered Phone number, the terminal
will hang up the phone call and the vibration detection function will be
enabled.
l The terminal will enter into the vibration detection status when the
OBD indicator was on for two minutes.
l Once a vibration was detected, an alarm SMS will send to the
registered phone number.
4.
Disable vibration detection
l After enabled the vibration detection function, call the terminal
through the registered phone number, the terminal will hang up the call and
disable the vibration detection function.
l When engine was turned on, the vibration detection function will be
disabled.
5.
Voice monitoring
l Call the service center through the registered phone number, after authorization,
the voice monitoring will be enabled.
l Call the terminal through the registered phone number, the terminal
will answer the phone call and enter into the voice monitoring status.
l Hang up phone call, the voice monitoring will be ended.
l If you need monitor again, please call the service center.
6.
Real time tracking
l Call the service center through the registered phone number, after authorization,
the real time tracking will be enabled.
l Terminal will upload the location information to the service center periodically.
l Inform the service center terminate the real time tracking service.
l If you need track again, please call the service center.
7.
Serious collision alarm
l Once a serious collision was detected by the terminal, the terminal
will send an alert message to the server with location information.
l The service center will contact the registered phone number to
verify the accident immediately.
l Once the accident has been confirmed, the service center will
contact the local rescue agent to carry out emergency rescue based on the location
information.
8.
Engine on and off notification
l Call the service center to apply for this function via registered
phone number.
l If the feature was opened, once the engine status has changed, a
notification SMS will send to registered phone number.
9.
Maintenance reminder
l Reminder based on the mileage interval.
l If an engine fault was detected, a reminder will be sent.
l If necessary, a reminder will be sent after the analysis of the
runtime conditions by server.
10.
Geofence
l 50 geofences can be set by server. When the car drives into or out
the restricted area, an alarm will be trigged.
11.
Trip report
l When the engine was turned off, a trip report will be uploaded to
the server. Beginning time/end time/mileage/highest speed/highest RPM/times of abrupt
deceleration & rapid acceleration/highest coolant temperature/duration of
drowsy driving/duration of excessive speed etc. will be included in the report.
l Please contact the service center to ask for this report.
12.
Battery monitoring
l Monitoring the battery voltage level all the time, once the battery
voltage goes below the preset value, a SMS reminder will be sent to the
registered phone number.
